• Bottle mouth expansion

  Reasons: 1. The ambient temperature is too high 2. The cooling effect of the oven airflow is low.Solution: 1. Adjust the position of the cooling class so that it can protect the thread of the preform ...

  2019-09-06 10:05

  22Hits

  0

• Neck bending

  Reasons: 1. Due to mechanical operation, the neck material is too thick to cause deformation after clamping.Solution: 1, optimize the mold structure2. The convex ring is tightly clamped in the recess ...

  2019-09-06 09:48

  28Hits

  0

• Bottom forming is not full

  Reasons: 1. The blowing pressure is not enough. 2. The preform temperature is slightly lower when blowing.Solution: 1. Check whether the high pressure filter on the side of the mold is smooth, so as n...

  2019-09-06 09:45

  33Hits

  0